English | Deutsch
RC Electronics / Motor controllers
|
ℹ️
|
Brushed DC-motor controller and V/ESC. |
Status |
🟡 experimental |
|---|---|
Hardware |
V1, V2 µC module, V2 power module (TARGET 3001!) |
Firmware |
|
Video |
2024-06-17, 2024-08-15, 2024-09-11, 2024-10-02, all videos (4) |
Features:
-
SBus(2)/IBus/SumDV3 serial input
-
SBus2/S.Port/IBus/Hott telemetry
-
PPM-Input
-
serial terminal configuration interface
-
telemetry
-
supply voltage
-
motor current
-
motor temperature (sensor needed)
-
motor rotational speed (no sensor)
-
The smaller one of the two versions comes as one pcb.
If you use Target 3001 as your EDA: Target 3001 design file.
The bigger one of the two versions consists of two pcbs, one pcb for the µC module and one pcb for the power module. Both are connected via two pin-header or the can be soldered directly back-to-back with one layer of capton-tape in between.
If you use Target 3001 as your EDA: Target 3001 design file.
If you use Target 3001 as your EDA: Target 3001 design file.
Status |
🟢 active |
|---|---|
Firmware |
|
Video |
Clearly, V/ESC is the king. The firmware provides sensorless FOC, that gives us full torque from zero RPM and silent motor operation. This comes together with an incredible configuration software.
Unfortunately the V/ESC project has only an analog PPM input, but no SBUS/IBUS/SumDv3 serial input.
This modification introduces a serial, half-duplex connection using the V/ESC serial commands for the FlipSky hardware:
Half-Duplex Modification VESC







